MICROPROCESSOR TRAINER KIT WITH LED DISPLAY SPECIFICATIONS Based on 8085 CPU operating at 6.144 MHz crystal 8K bytes of EPROM loaded with powerful monitor program 8K bytes of RAM available to the user Total on board memory expansion upto 64K bytes using 2732/2764/27128/6264/ 62256 with 1 socket of 28 pin Battery back up for RAM with 3.6V rechargeable cell Memory mapping definable by the user 16 bit programmable TIMER/COUNTER using 8253 Additional serial port using 8251 (OPTIONAL) Real Time Clock (OPTIONAL) 48 I/O lines provided through 8255 RS-232C interface through SID/SOD Lines with Auto baud rate Two modes of commands: Hex Key pad & Serial mode All address, data & control lines are buffered and made available at the edge connector as per STD bus configuration 25/28 key hexadecimal keyboard and six seven segment displays through 8279 Powerful software commands like Relocate, String, Fill, Insert, Delete, Block Move, Examine/Compare Memory, Examine Register, Insert Data, Delete Data, Single Step, GO, Break Point in both Serial & Keyboard mode Facility for Downloading/Uploading files from/to PC Enclosed in an attractive ABS plastic cabinet with cover In-built Power supply User's Manual
SPECIFICATIONS
Based on 8085 CPU operating at 6.144 MHz crystal frequency.
8/16K bytes of EPROM loaded with powerful monitor program.
8/16K bytes of RAM available to the user.
Battery Backup for RAM with 3.6V rechargeable cell.
Total on board memory expansion upto 64K bytes.
Memory mapping definable by the user.
Three nos. of 16 bit programmable TIMER/COUNTER�using 8253.
48 programmable I/O lines provided through two nos. of 8255.
RS-232C interface for CRT Terminal with auto baud rate.
EPROM Programmer for 27 series EPROM with facility to Program, Verify, List & Blank Check.
Two modes of commands: Hex Key pad mode & Serial mode
All address, data & control lines are buffered and made available at 50 pin FRC connector as per STD bus configuration.
28 key hexadecimal keyboard and six seven segment display through 8279.
Powerful software commands like Relocate, String, Fill, Insert, Delete, Block Move, Examine & Compare Memory, Examine Register, Insert Data, Delete Data, Single Step, Go, Break Point in both Serial and Keyboard mode.
On board Single Line Assembler and Disassembler.
Faclity for Downloading/Uploading files from/to PC.
Power supply requirement: +5V/1.2A, +/-12V/250mA, +24V/21V/100mA